Oscillation and reaction board techniques for estimating inertial properties of a below-knee prosthesis.

Jeremy D. Smith, Abbie E. Ferris, Gary D. Heise, Richard N. Hinrichs, Philip E. Martin

    Research output: Contribution to journalArticlepeer-review


    The purpose of this study was two-fold: (1) demonstrate a technique that can be used to directly estimate the inertial properties of a below-knee prosthesis, and (2) contrast the effects of the proposed technique and that of using intact limb inertial properties on joint kinetic estimates during walking in unilateral, transtibial amputees. An oscillation and reaction board system was validated and shown to be reliable when measuring inertial properties of known geometrical solids. When direct measurements of inertial properties of the prosthesis were used in inverse dynamics modeling of the lower extremity compared with inertial estimates based on an intact shank and foot, joint kinetics at the hip and knee were significantly lower during the swing phase of walking. Differences in joint kinetics during stance, however, were smaller than those observed during swing. Therefore, researchers focusing on the swing phase of walking should consider the impact of prosthesis inertia property estimates on study outcomes. For stance, either one of the two inertial models investigated in our study would likely lead to similar outcomes with an inverse dynamics assessment.

    Original languageEnglish (US)
    JournalJournal of visualized experiments : JoVE
    Issue number87
    StatePublished - 2014

    ASJC Scopus subject areas

    • General Medicine


    Dive into the research topics of 'Oscillation and reaction board techniques for estimating inertial properties of a below-knee prosthesis.'. Together they form a unique fingerprint.

    Cite this